There's a lot more to a service than people realise. Here's a breakdown of everything carried out.
1. Inspect pump chamber, wet well, and surroundings.
Check for corrosion, leaks, blockages, or damage to equipment.
Confirm all safety signage, rails, and covers are in good condition.
2. Manually test each pump individually.
Verify automatic operation via float switches or level sensors.
Monitor run times, start/stops, and pump alternation (if multiple pumps).
Check amperage draw to detect overloading or failing motors.
Check insulation resistance on the pump motor and continuity across phases on a 3 phase system.
3. Clean float switches or ultrasonic level sensors.
Test their function (start/stop trigger points).
Adjust float levels if needed.
4. Check Valves and Discharge Lines
Inspect check valves to ensure they prevent backflow.
Flush or inspect discharge pipes for blockages or build-up.
Confirm there are no leaks or pressure drops.
5. Inspect control panel (including timers, relays, contactors).
Test backup systems (battery backup or generator, if applicable).
Ensure alarm systems (audio/visual, SMS alerts) work properly.
6. Inspect and test each pump for wear and tear.
Check for signs of bearing failure, seal leaks, or impeller damage.
Lubricate parts if necessary.
7. Log pump run times and performance data.
Provide a report on system condition, potential issues, and recommendations.
All these tests will take 1-2 hours depending on system size.
